Lutz BE10 - Page 23

23
0698-651 Operating unit - 04/2021
en
Explanation of the display
1 Top title
2 Button to call up the menu level
3 Symbol - Liquid is registered
4 Symbol - External actuation is active
5 Symbol-ValvefunctionOnorOpointisactive
6 Button for help function
7 Symbol - Overrun correction is active
8 Symbol - Programming lock is active
9 Symbol - Relays 1 and 2 are active
10 Unit of measurement
11 Button
12 Scroll backwards
13 Scroll forwards
14 With this button you leave the menu level and go back to the operating display.
15 Set value
16 Aktive function
17 With this button you cancel the entry and return to the previous menu level.
18 With this button you save the setting and return to the previous menu level.
19 Withthisbuttonyouswitchthefunctiononoro
20 With this button you change the set value.
21 Menu bar
22 Function not available in the existing system equipment.
23 Page 4 of 5 of the display
24 Small display
25 Large display
26 Operating mode
You can use some functions only if the respective module is connected to the operating unit. One of the
following symbols is shown for the explanation of the function:
RM
For the function a relay module is necessary.
TM
For the function a button module is necessary.
KM
For the function a communication module is necessary.
NG
For the function a power supply unit is necessary.