Lutz BE10 - Current Settings

31
0698-651 Operating unit - 04/2021
en
9.4 Current settings
You can use this function to view all present settings.
Set operating mode. Abbreviations: MAN (Manual mode), AUTO (Volume
preset), Disp. (Display mode)
Set display: The front letter stands for the large display; the rear letter for the
smaller display. Abbreviations: P (Partial volume), T (Total volume), F (Flow
rate), A (Added volume), V (Volume preset), R (Remainder), C (Cycle counter)
Current calibration factor
Set language: Deutsch, English, Espanol, Francais, Italiano, Nederlands, Por-
tuguês,РУССКИЙ
Unit of measurement for volume display: L (Liter), m³, kg, t, US-G (US-gallons),
IMP-G (Imperial-gallons), cu.ft. (Cubic feet), lb (pound)
Unit of measurement for time display: s (Second), min (Minute), h (Hour)
Number of decimal places: 0, 1, 2, 3
Fault detection: On, O
Monitoring time: Time value
Valvefunction-Opoint:On, O
Valvefunction-Opoint:Timevalue
Valve function - On point: On, O
Valvefunction-Opoint:Timevalue
Flow monitoring: On, O
Flow monitoring - Lower limit: Flow rate
Flow monitoring - Upper limit Flow rate
Economy: Cmpl(Displayisswitchedocmpl.),Part(Displayisswitchedo
except measured values), Nvr(Displayisswitchedonever)
Leakage al.: On/O
Overrun correction: On/O
External actuation: On/O
Current setting 1/5
Current setting 2/5
Current setting 3/5
Op. mode: AUTO
Display: AV
C. factor: 1,001
Language: English
Time: min
D. places: 1
Volume: L
Fault det.: On
M. time: 3 s
Valve function:
Off point: Off
On point: Off
Val.: 5 s
Val.: 5 s
Flow mon.: Off
LL: 1 L
UL: 100.5 min
Economy: Nvr
Overrun: Off
Ext. act.: Off
Leakage al.: On