Lutz BE10 - Resetting to Factory Settings; Displaying SW Version

64
0698-651 Operating unit - 04/2021
en
9.27 Resetting to factory settings
The following values and functions are reset:
Display options, Calibration factor (1), Unit of measurement (L/min), Decimal
places(1),Economy(Switchopart.),Backlight(O),Faultdetection(On),
Onpoint(O),Opoint(O),Leakagealarm(O),Overruncorrection(O),
Externalactuation(O),Safetyprompt(On),Flowmonitoring(O),Digital
input(O),Alarmoutput(O),RS485(Aus),Analogoutput(O),Pulse
output(O),MeasurementOn/O(On),Programminglock(O).
9.28 Displaying SW version
Menu
?
RESET
MAN
Meas. on/off
Coupling mod ules
Programming lock
Factory settings
SW version
Menu 5/5
?
?
Factory settings
?
?
OK
Cancel
Reset device
to factory
settings?
Caution
All saved user
settings will be
deleted!
Syst. info
OK
Cancel
Really reset
to factory
settings?
Syst. info
OK
Device reset
to factory
settings.
Menu
?
RESET
MAN
Meas. on/off
Coupling mod ules
Programming lock
Factory settings
SW version
Menu 5/5
?
?
SW version
OK
Operating unit
1.0.19
Relay module
1.0.19
Basic flow meter
1.0.19
Com. module
------