Lutz BE10 - Page 30

30
0698-651 Operating unit - 04/2021
en
Youcanusethisfunctiontoswitchthemeasuringactivityoftheowmeteronor
o.Thisishelpfulforcommissioningandmaintenancework(→ chapter 9.24).
Intheowmetersystem,multipleoperatingunits,relaymodules,andbasic
owmeterscanbeconnectedup.Arelaymoduleandabasicowmeterform
aunit.Theoperatingunitonlyworkswithabasicowmeterorwithaunit
consistingofrelaymoduleandbasicowmeterinallcases.Youcanusethis
functiontocoupleupabasicowmeterandarelaymoduletoformaunit.In
the case of multiple units you select which one is actuated by the operating
unit.Thisfunctionisonlyactiveifmultiplebasicowmetersorrelaymodules
are connected up (→ chapter 9.25).
Youcanusethisfunctiontoprotectimportantowmetersettingsfrombeing
changed by unauthorized persons. To do so, enter a 4-character numerical
code (→ chapter 9.26).
Youcanusethisfunctiontosetallowmeterselectionoptionsbacktothestate
they were in at delivery (→ chapter 9.27).
You can use this function to view the SW version of the active modules
(→ chapter 9.28).
Meas. on/off
Coupling modules
Programming lock
Factory settings
SW version
Menu 5/5
?
?