Rev #2 Version 3.00 August 2020
Page 56 of 80
Select the Wi-Fi you wish to connect to and a new menu will open where you can type in the
password and enable or disable DHCP.
6.8.9.7 IP NMEA
Here you can enable or disable TCP/IP NMEA sentences. You can also see your Nano
4
access point (format: NANO4-xxxx) or set-up IP address, port number, netmask and
gateway.
6.8.10 FLARM
If a FLARM is detected the user can make some configuration setting changes on the FLARM
and display some FLARM status information.
6.8.11 Files
The NANO
4
supports CUP file format for waypoints, CUB file format for airspace, FLN for
FlarmNet files and CIT file format for the maps.
To Next Page
Loading...
