LXNAV NANO4 - Automatically Finish Flight; Changing Parameters with Nanoconfig; Flight Recording Interval; Start Recording on Power on

Rev #2 Version 3.00 August 2020
Page 71 of 80
8.3.2 Changing Parameters With NanoConfig
Run the NanoConfig program and go to the settings screen which is split into two sections:
settings dedicated to the NANO
4
and settings for NanoConfig.
Parameters for the NANO
4
include the recording interval, a NMEA output and a Bluetooth
enable setting.
In NanoConfig you can change the distance units used in the task declaration and the
latitude/longitude format.
8.3.2.1 Flight Recording Interval
The flight recording interval is set to one second by default. It is recommended that you
keep this setting. Even with the recording interval set to one second, the NANO
4
can store
approximately 28000 hours of flight. Having a recording interval of one second will allow
you to do more accurate post-flight analysis and it increases the probability of obtaining a
data point in the observation zone.
If you wish to change these settings use the up/down arrow or enter a new value.
8.3.2.2 Automatically Finish Flight
If this option is enabled the flight will automatically finish and be digitally signed once
conditions for finishing the flight are met. The NANO
4
must fulfil the following conditions for
30 seconds: GPS status is OK, ground speed is below 4 m/s, vertical speed is within 0.2 m/s
and altitude is below 3000 m.
8.3.2.3 Start Recording on Power On
If this option is enabled recording of a new flight will automatically start when the NANO
4
is
powered on. If this option is disabled the NANO
4
will start recording when the vertical speed
is above 1 m/s, and the ground speed is above 8 m/s. This option is most useful for
paragliders.
When this option is enabled the Automatic finish option is ignored.