LXNAV S100 - Page 6

Rev #37 Version 8.0 April 2021
Page 6 of 121
5.7.15 Profiles 83
5.7.16 Password 84
5.7.16.1 List of Password Functions 84
5.7.17 Admin Mode 85
5.7.18 About 85
6 Variometer and Altimeter 86
6.1 Altimeter 86
6.2 Speed Command 86
7 Hawk 87
7.1 Introduction 87
7.2 Wind Model 87
7.3 The Aerodynamic Model 90
7.4 Summary and Recommendation 92
7.5 HAWK system activation 92
7.6 Setup parameters 92
7.6.1 Netto Vario 92
7.6.2 Relative Vario 93
7.6.3 HAWK Parameters 93
7.6.4 Graphical display 93
7.6.5 Audio source 93
8 Flying with the LXNAV S8x/S10x 94
8.1 On the Ground 94
8.1.1 Power on Procedure 94
8.1.2 Set Elevation and QNH 94
8.1.3 Pre-Flight Check 95
8.2 Airborne 95
8.2.1 Final Glide Calculation 95
9 Installation 96
9.1 Installing the LXNAV S8x/S10x 97
9.2 Connecting the LXNAV S8x/S10x 97
9.3 Cutouts 98
9.3.1 Cut-Out for S8 and S10 98
9.3.2 Cut-Out for S80 and S100 98
9.4 Available Cables for GPS/FLARM and PDA Ports 99
9.5 Installation of Options 100
9.5.1 S8xD Option (Repeater) 100
9.5.1.1 Data Exchange 100
9.5.2 Magnetic Compass (Compass – CAN) 101
9.5.3 Flap Sensor (Flap – CAN) 101
9.5.4 Remote Stick (Remote-CAN) 101
9.5.5 AHRS Option and HAWK option 102
9.5.5.1 Activation using a license file 102
9.5.5.2 Activation using a license key 102
9.6 Ports and Wiring 104
9.6.1 LXNAV S8x Ports 104
9.6.1.1 PDA Port (RJ45) 104
9.6.1.2 GPS Port (RJ12) 104
9.6.1.3 Main Port 105
9.6.1.4 Audio Port 105
9.6.2 Wirings 106
9.6.2.1 LXNAV S8X Wiring 106
9.6.2.2 LXNAV S10x Wiring 107