215626 78 Revision A
$
Figure 4.13: Drive Roller Cross Section
9. Slide the drive roller onto the DWA motor shaft. Make sure
it is fully engaged.
NOTE:
The drive roller should be 33 mm (1 1/3 in.) from the face
of the motor (distance [A]).
$
%
Figure 4.14: Draper Drive Roller
10. Install two setscrews (B). Torque the screws to 27 Nm
(20 lbf·ft).
11. Install two jam nuts (A).
$
Figure 4.15: Draper Drive Roller
12. Torque bolt (A) to 95 Nm (70 lbf·ft).
MAINTENANCE AND SERVICING
To Next Page
Loading...
