5
Open
the
battery door and remove
the
LI-ION battery,
exposing
the
SD
Card Cradle.
Lightly press
on
the
SD
Card Cradle Release and
the
cradle will spring open.
SO
Card
Cradle
Release
With
the
cradle open, slide
the
SD
card in
the
cradle
(shown in gray).
Do
NOT lay
the
SD
card
flat
in
the
battery
compartment
as
damage
will
occur when
closing
the
SD
Card Cradle. Gently push the
SD
card
cradle back down
until
it
locks into place.
Put
the
LI-ION battery back in the battery
compartment
and secure the battery door.
Turn your eXplorist
off
and connect
the
round connector
of
the
eXplorist data cable
to
the
back of your eXplorist and
tighten
the
locking screw. There are alignment tabs
on
the
connector to make
sure
that
the
connector is installed properly.
It
is recommended
that
you connect
the
eXplorist
to
external power using
the
external
AC
power adapter.
The other end
of
the
eXplorist data cable has a standard USB
connector
that
you connect to your personal computer USB ports
(normally found
on
the
back of your personal computer). Turn your
personal
computer
on
and then
turn
on
your eXplorist.
You
may
see a message
on
your computer
indicating
that
it
has found a new
USB hardware device.
On
your eXplorist, a screen is displayed
indicating
that
it
is in USB File transfer mode.
Right
click
the
"My
Computer" icon
on
the desktop of your Connecting
the
Cable
computer
and select
the
"Explore" option.
If
you have
an
SD
card
installed in your eXplorist you will see a new device named "Removable Disk". From here
you are able
to
copy files to and from
the
installed
SD
card
to
your computer.
To Next Page
Loading...
Need help?
General
