46
Creating a
GOTO
Route
from the
Map
Cursor
This will create a
GOTO
route
to a point
on
the
map
that
you
have
indicated
by
moving the
crosshair cursor
on
the
Map
screen.
1. While viewing the
Map
screen,
use
the
Arrow
joystick, causing the eXplorist to
go
into
Cursor
mode.
2.
Continue using the
Arrow
joystick to
move
the crosshair cursor to a point
on
the
map
that represents
where
you
w~nt
to
go.
3.
Press
GOTO.
4.
If a
GOTO
is
active,
you
will
be
asked
to deactivate
it
and
create a
new
GOTO
route.
Highlight
Yes
and
press
ENTER
to overwrite the existing
GOTO.
You
are
then
asked
whether
you
want
to
create a
new
GOTO
route. Highlight
Yes
and
press
ENTER.
5.
Confirm that
you
want
to create a
GOTO
from the current cursor position. Highlight
Yes.
(If
you
highlight
No
and
press
ENTER,
the eXplorist
assumes
that
you
still want
to
create a
GOTO,
just not to the current cursor position.
The
POI
database
screen
will
be
displayed
so
that
you
can
search
the
database
for the
POI
you
want to
use
as
the destination.)
6.
Press
ENTER.
After
you
press
ENTER,
the last
viewed
navigation
screen
will
be
displayed, updated
as
needed
to provide information about the
GOTO
route
you
have
created.
On
the
Map
screen,
a
line will
be
drawn
representing the
GOTO
route.
The
Compass
screen
will
change
to display
the
name
of the
POI
used
as
the destination
in
the
screen
header
bar
and
an
icon
representing the destination outside the
compass
diameter.
To Next Page
Loading...
Need help?
General
