Magellan eXplorist - Deleting All Pols from the Area Calculation List; Editing the POI List in Area Calculation

71
6. Highlight <Add Point>.
7. Press ENTER.
Note: Any previous area calculations you did are saved in memory and will be
displayed. To create a new area calcu lation you wi II first need to delete all of the
POls from the list. How to delete all of the POls will be explained following these
instructions.
8. Using the
POI database, select a stored POI.
9. Repeat steps 6 through 8 until you have a region defined.
10.
The bottom of the display wi II alternate between the area and the perimeter of the
region you have defi ned.
Deleting AU POls from the Area Calculation List
1. While viewing the Area Calculation screen, press MENU.
2. Highlight Delete All Points.
3. Press ENTER.
4. All of the POls in the list are removed and you can now create a new region to be
calculated.
Editing the POI List in Area Calculation
You can insert, delete, or replace a POI in the area calculation list.
1. Use the Arrow joystick to highlight the POI in the list that you want a new POI
added before, deleted, or replaced.
2. Press MENU.
3. Use the Arrow joystick to highlight Insert Above, Delete, or Replace.
4. Press ENTER.
5. If you select Insert Above or Replace, you will select a POI from the POI
database.