10
To
turn
the
eXplorist on, press
the
POWER
button
on
the
top
right
side.
To
prevent
the
eXplorist from being turned
on
accidentally,
draining the batteries, you need to press
ENTER
when the Startup
screen is displayed.
You
have approximately
30
seconds between
pressing the
POWER
button and pressing the
ENTER
button,
otherwise the eXplorist will automatically turn itself off.
To
turn
the
eXplorist off, press the
POWER
button
on
the top right
side.
There is a 5-second countdown after you press
the
POWER
button.
If
you change your
mind
and decide to leave the eXplorist on,
just
press
the
ESC
button.
If
you press the
POWER
button during
this
countdown period,
the
eXplorist will immediately
turn
off.
©
2005
Thales
Navigation
PRESS S
POWER
DOWN
IN
4
SECONDS
PRESS
ESC
KEY
TO
CANCEL
The display backlight has three levels of intensity: high, medium, and low. When the
eXplorist is
first
turned on, the display backlight is set to high. Press the
LIGHT
button
on
the
top
left
side of
the
eXplorist to turn
the
backlight
on
medium. Pressing
the
LIGHT
button a second
time
sets the backlight to low.
To
turn the backlight back to high, press the
LIGHT
button again.
Backlight
intensity changes
each
time
you
press
the
LIGHT
button.
REMEMBER:
Using the display backlight
on
high causes severe
drain
on
the batteries.
To Next Page
Loading...
Need help?
General
