100
HHmm00: Time remaining to destination waypoint, HH from 00 to 99, mm from 00
to 59.
Version 1.5:
C- -C: Waypoint identification in 4 letters
Version 2.0 and Version 2.3:
C- -C: Waypoint identification in 6 letters
*hh: Sentence checksum
PML2: Programming of the differential receiver
$PML2, XXX.X, 0, Z
XXX.X: DGPS frequency in kHz
Z: Transmission speed: 1 = 100 BAUDS, 2 = 200 BAUDS
PML3: Reception of differential receiver
$PML3, XX, YYY, ZZZ.Z, WW,NNNN
,E*hh
XX: Reception rating
YYY: Rate of error for differential reception
ZZZ.Z: DGPS frequency in kHz
WW: Number of corrected satellites
NNNN: Differential station number
E: Station status
*hh: Sentence checksum
PML5: Coordinate grid
$PML5, XXXXXXXXXX, 4710.7056,N,00115.6984,W*hh
4710.705,N: Latitude, N/S
00115.698,W: Longitude, E/W
XXXXXXXXXX = 1/10000MIN for latitude and longitude in thousandths of a minute
XXXXXXXXXX = 1/1000MIN for latitude and longitude in hundredths of a minute
XXXXXXXXXX = 1/10SEC for latitude and longitude in seconds
XXXXXXXXXX = UTM for position in UTM
XXXXXXXXXX = LAMBERT1 for position in Lambert 1
XXXXXXXXXX = LAMBERT2 for position in Lambert 2
XXXXXXXXXX = LAMBERT3 for position in Lambert 3
XXXXXXXXXX = LAMBERT4 for position in Lambert 4
XXXXXXXXXX = GRADES for position in grades
XXXXXXXXXX = GR.BRIT for position in British Grid
XXXXXXXXXX = Gr.IREL for position in Irish Grid
XXXXXXXXXX = Gr.REUN for position in Reunion Island Grid
XXXXXXXXXX = Gr.SUIS for position in Swiss Grid
XXXXXXXXXX = Gr.TAIW for position in Taiwanese Grid
To Next Page
Loading...
Need help?
General