5
Table of Buttons and their Functions
Button Function Note
PWR Turns the device on or off and allows
you to set the backlighting and contrast
(FX324 MAP only).
Hold down the button for 4 to 5
seconds to turn off the device.
Push the button briefly to set the
contrast and screen backlighting.
Pos Displays the Position screen, which
allows you to read essential information
pertaining to your position.
Push the button a second time to
display the second Position
screen.
Nav Displays the Navigation screen, which
allows you to view your speed and your
course over the ground.
Push the button a second time to
display the second Navigation
screen.
GoTo Displays the GoTo screen, which directs
you toward a waypoint and enables you
to follow a route.
Push the button a second time to
display the second GoTo screen.
Plot Displays the Plotter screen which
enables you to follow your position and
your route on the chart.
Push the button a second time to
display the second Plotter screen.
0-9 Keypad that allows you to enter
alphanumeric values.
Hold the button down to access
the alphabet keypad. For
example, holding the 2 button
down displays the letters a, b and
then c.
Z- (7) In the Plotter function, hold this button
down to zoom out.
Also enables you to change the
zoom scale in GoTo-3D Road
mode.
Z+ (9) In the Plotter function, push this button to
zoom in.
Also enables you to change the
zoom scale in GoTo-3D Road
mode.
Zoom (8) In the Plotter function, push this button to
select the zoom scale from a list or
activate the automatic zoom mode.
(5) In the Plotter function, push this button to
choose a waypoint and center it on the
screen.
Curs (2) In the Plotter function, push this button to
activate/deactivate the cursor mode.
Menu Displays the menus that allow you to
configure the settings for your device.
If you press Menu while on the
Position, Navigation, GoTo or
Plotter screens, the corresponding
menu automatically appears.
To Next Page
Loading...
Need help?
General