69
Activating the Over Zoom Mode
When this mode is active, the OVERZOOM indication appears when the
selected zoom scale makes it impossible to display the chart with a good
definition.
If the Over zoom mode is not active, only the zoom scales allowed by the
loaded chart are available.
Menu Æ PLOT Tab Æ 8-Over zoom
Select Yes (active) or No (inactive) and push Enter.
Note: You must be very careful when the OVERZOOM indication is
displayed on the Plotter screen since the lack of definition for the
chart causes discrepancies with the reality.
To Next Page
Loading...
Need help?
General