Catch Sensors | V1 | System Configuration and Display
Catch Sensor
Note: The options (depth, temperature, etc.) vary according to the firmware
installed.
1 Sensor name displayed in Scala and its features.
2 This setting helps detecting the signal of the sensor among other sensor or
echosounder signals. Change only if you have issues receiving data.
•
Detection and 2D: default value. This setting helps distinguishing the sensor
signals when there are a lot of interferences (e.g. echosounders). It selects the
correct signals according to very selective criteria.
•
Detection: If you do not receive data, it may be because the Detection and 2D
setting is too selective with the signal. Detection is less selective and allows
more signals to be received.
•
Detection for Seiner: no need for this sensor
3
•
Low: if the signal of the sensor is high = the trawl is close to the vessel (SNR
min. 18dB).
•
Medium: Default setting. Compromise between the two other settings (SNR
min. 12dB).
•
High: if the signal of the sensor is low = the trawl is far from the vessel (SNR
min. 6dB).
4
Enter the same frequencies as those entered in Mosa in Boat Code/Channel Codes.
5 Enter the same telegrams as those entered in Mosa for each option.
| 46
To Next Page
Loading...