Catch Sensors | V1 | Servicing and Maintenance
2.
Remove the retainer ring around the transducer (yellow part).
3.
To remove the black tube around the bottle, place the bottle in a vise or on the ground
and pull out the black tube.
You have now access to the electronic components.
4.
Remove the tape protecting the components.
5.
Disconnect the battery from the PCBA.
6.
Remove the PCBA to get access to the back of the end cap:
a)
Remove the four screws holding the retainers on each side of the PCBA with a 1.5
mm Allen key.
b)
Remove the PCBA and retainers.
| 69
To Next Page
Loading...