Matrix Sparsh VP110

Matrix SPARSH VP110 User Guide 267
To configure LLDP via web user interface:
• Click on Network->Advanced.
• In the LLDP block, select the desired value from the Active list.
• Enter the desired time interval in the Packet Interval (1~3600s) field.
• Click Confirm to save the change.
A dialog box pops up to prompt that settings will take effect after a reboot.
• Click OK to reboot the IP phone.
Local WebUserInterface
ConfigureLLDP.
Navigateto:
http://<phoneIPAddress>/
servlet?p=network‐adv&q=load