Matrix Sparsh VP110

386 Matrix SPARSH VP110 User Guide
Call Waiting
Parameter-
phone_setting.inter_digit_time
ConfigurationFile
<MAC>.cfg
Description
Configuresthetime(inseconds)forthephoneto
automaticallydialouttheentereddigitswithout
pressinganyotherkey.
Note
:Itworksonlyiftheparameter
“phone_setting.predial_autodial”issetto1(Enabled).
Format Integer
DefaultValue 4
Range 1to14
Example phone_setting.inter_digit_time=4
Parameter-
call_waiting.enable
ConfigurationFile
<MAC>.cfg
Description
Enablesordisablescallwaitingfeature.
Ifitissetto0(Disabled),anewincomingcallis
automaticallyrejectedbytheIPphonewithabusy
messagewhileduringacall.
Ifitissetto1(Enabled),theLCDscreenwillpresenta
newincomingcallwhileduringaca
ll.
Format Boolean
DefaultValue 1
Range
Validvaluesare:
0‐Disabled
1‐Enabled
Example
call_waiting.enable=1
Parameter-
call_waiting.tone
ConfigurationFile
<MAC>.cfg
Description
Enablesordisablestheplayingofacallwaitingtone
whentheIPphonereceivesanincomingcallduringa
call.
Ifitissetto1(Enabled),theIPphonewillperforman
audibleindicatorwhenreceivinganewincomingcall
duringacall.
Note
:Itworksonlyiftheparameter
“call_waiting.enable”issetto1(Enabled).