Matrix SPARSH VP110 User Guide 49
To configure a static IPv4 address via web user interface:
• Click on Network->Basic.
• In the IPv4 Config block, click Static IP Address.
• Enter the desired values in the IP Address, Subnet Mask, Gateway, Primary DNS and Secondary DNS
fields.
• Click Confirm to save the change.
A dialog box pops up to prompt that settings will take effect after a reboot.
• Click OK to reboot the IP phone.
To configure the IP address mode via phone user interface:
• Press Menu->Settings->Advanced Settings (password: 1234) ->Network->WAN Port.
• Press or to select IPv4, IPv6 or IPv4 & IPv6 from the IP Mode field.
• Press the Save soft key to save the change.
• Reboot the IP phone to apply the changes.
To Next Page
Loading...
