MAXDATA PLATINUM - Server Menu

MAXDATA PLATINUM Server Board User’s Manual
48
Security Menu (continued)
Feature Choices Description
Video Blanking Disabled Blank video when secure mode is activated.
Enabled A pass word is required to unlock the system.
This option only appears on the screen after a
“user” password has been entered.
Power Switch Inhibit Disabled
Enabled When enabled, the power switch is inoperable.
This option only appears on the screen after a
“user” password has been entered.
Server Menu
Feature Choices Description
System Management Press <Enter> Enters Submenu.
Console Redirection Press <Enter> Enters Submenu.
Event Log Configuration Press <Enter> Enters Submenu
Service Boot Enable
Disable If enabled, server boots directly to System Management.
Assert NMI on PERR Disabled
Enabled If enabled, PCI bus parity error (PERR) routes to NMI.
Assert NMI on SERR Disabled
Enabled If enabled, PCI bus system error (SERR) routes to NMI.
FRB-2 Policy Disable BSP Controls the policy of the FRB-2 timeout.
Do not Disable BSP This option determines when the Boot Strap Processor
Retry 3 Times (BSP) should be disabled if an FRB-2 error occurs.
BMC IRQ Disabled Sets the BMC IRQ.
IRQ 5
IRQ 11
After Power Failure Stays Off Determines the mode of operation if a power loss occurs.
Last State
Power On
Temperature Sensor Disabled If enabled, the system will not boot if the ambient
Enabled system temperature is outside the range specified in the
Sensor Data Record (SDR).
POST Error Pause Disabled If enabled, the system will wait for user intervention on
Enabled critical POST errors.
Platform Event Filtering Disabled Enable/Disable triggers for system sensor events inside
Enabled the Baseboard Management Controller (BMC).