MAXDATA PLATINUM Server Board User’s Manual
69
File
The File menu has the following options:
• Save: Allows you to save the configuration immediately.
• Close: Allows you to close the Emergency Management Port dialog without saving
changes. If you have made changes, you will be prompted to save changes before closing.
Options
The Options menu has the following options:
• Clear EMP Password: Allows you to clear the currently saved EMP password. This takes
effect immediately. This option is only available if the EMP password is set.
Help Topics
The Help Topics menu has the following options:
• Help Topics: Displays help information.
Enter New Password
Enter an EMP password. The valid range of characters includes ASCII values 32-126. The
password must be from 1-1 6 characters long.
Verify New Password
Enter the same password as above.
ESC Sequence
The ESC Sequence string is sent to the modem before sending a command string to the
modem. The length of the paging string is determined at run-time from firmware. You will be
notified if the string is truncated. The string that has been saved is the one that will be shown
in the edit box.
Hangup String
The Hangup Line string is sent to the modem whenever the EMP wants to terminate the
session. The EMP automatically sends an <ENTER> character after this string. The length of
the paging string is determined at run-time from firmware. You will be notified if the string is
truncated. The string that has been saved is the one that will be shown in the edit box.
Modem Init String
The Modem Init String string is transmitted every time the EMP initializes. The length of the
paging string is determined at run-time from firmware. You will be notified if the string is
truncated. The string that has been saved is the one that will be shown in the edit box.
System Phone Number
Enter the system telephone number. This can be retrieved and reported via in-band manage-
ment connections.
Access Mode
In Pre-boot Only the EMP is automatically activated when the system is powered-down or
hard reset. In Always Active the EMP is active when the system is powered-down or hard
reset. In Disabled the EMP powers-up deactivated and is not automatically activated by
BIOS, power-down or hard resets.
Restricted Mode Access
When restricted mode is enabled control operations that could disable or alter a running
system via the EMP are disabled.
To Next Page
Loading...
