MELER GLUING SOLUTIONS TABLE OF CONTENTS
Installation requirements 3-1
Free space 3-1
Electrical consumption 3-2
Compressed air 3-2
Other factors 3-2
Unpacking 3-3
Contents 3-3
Mounting the equipment 3-3
Electrical power supply connection 3-3
Pneumatic connection 3-4
Hose and applicator connection 3-4
Programming parameters 3-5
Programming working temperatures 3-5
Selecting the overheating value 3-5
Keeping a component on display 3-6
External I/O connections 3-6
Temperature ok 3-7
External standby 3-7
Starting up the motor (ok ext) 3-8
Motor speed set point reference (ref ext) 3-9
Failures output in pump control card 3-9
4. MELTER OPERATION 4-1
General information 4-1
Loading the adhesive 4-2
Starting up the melter 4-2
Melter displays 4-3
Temperature display for each component 4-4
Alarm display 4-4
Temperature adjustment 4-5
Programming the melter parameters 4-6
To Next Page
Loading...
