To Next Page

To Previous Page

MI 3102(H) BT EurotestXE Data handling

7.6 Communication

Stored results can be transferred to a PC. A special communication program on the PC

automatically identifies the instrument and enables data transfer between the instrument and

the PC.

There are three communication interfaces available on the instrument: USB, RS 232 and

Bluetooth.

7.6.1 USB and RS232 communication

The instrument automatically selects the communication mode according to detected interface.

USB interface has priority.

Figure 7.14: Interface connection for data transfer over PC COM port

How to establish an USB or RS-232 link:

 RS-232 communication: connect a PC COM port to the instrument PS/2 connector using

the PS/2 - RS232 serial communication cable;

 USB communication: connect a PC USB port to the instrument USB connector using the

USB interface cable.

 Switch on the PC and the instrument.

 Run the EurolinkPRO program.

 The PC and the instrument will automatically recognize each other.

 The instrument is prepared to communicate with the PC.

The program EurolinkPRO is a PC software running on Windows XP, Windows Vista, Windows

7, and Windows 8. Read the file README_EuroLink.txt on CD for instructions about installing

and running the program.

Note:

 USB drivers should be installed on PC before using the USB interface. Refer to USB

installation instructions available on installation CD.

METREL EurotestXE User Manual

Questions and Answers: