EN
Control CS 310 / Rev.I 1.55 – 43
The following messages can be read from the error memory, but are not displayed in the AUTOMATIC operating mode:
Display Meaning Status
POWER ON Counter for switching the supply
voltage off and back on again.
Counts up by actively switching the supply on and off, or with power failures.
ERROR SUPP.VOLT. Counter for the occurrence of deviations
in the supply voltage.
Overvoltage and undervoltage are detected and counted.
RESTART Restart counter Display of the restarts executed. Caused by detection of undervoltage, change of the
limit position system or after a RESET of the controller.
To Next Page
Loading...
Need help?
General
