MG HS PHEV - Page 284

EMERGENCYINFORMATION
domedheadofthejackmusttintothecorresponding
recessinthesillplate(Thereisatriangleindicatorinthe
areashownbythearrowhead.Seetheillustrationabove).
T urningthejackscrewbyhand,adjustthejackuntilthejack
headtssnuglyontothesillinthecorrectarea.Ensurethat
thebaseofthejackisinfullcontactwiththelevelground.
FittingtheSpareWheel
Regularlycheckthesparewheeltyre
pressure,itmaynotbeusedforlong
periodsoftime.Aftertment,attherst
opportunitycheckandadjustthetyre
pressure.
Thewheelboltsmustbetightenedtothe
speciedtorqueafterchangingawheel
(120
～ ～
～
130Nm).
1Beforeraisingthecar,usethespecialtoolsupplied
withthevehicletoremoveeachwheelboltcap.Use
thewheelboltspannertoslackeneachbolthalfaturn
anti-clockwise.
2T urnthehandleinaclockwisedirectionuntilthetyre
isclearoftheground.
3Removethewheelboltsandplacetheminthetooltray
topreventthemfrombeinglost.Makesurethevehicle
issteadyandthereisnoriskofslipormovement
beforeremovingwheelbolts.
4Removetheroadwheel.
Note:Avoidplacingwheelsfacedownonthe
ground-thesurfacemaybescratched.
5Fitthesparewheelandtightenthewheelboltswith
wheelboltspanneruntilthewheelisseatedrmly
againstthehub.
6Lowerthecarandremovethejack,thenFULL Ytighten
thewheelboltsinadiagonalsequence.
7Finally,returnthetoolstothetoolbox,putthetoolbox
intothewellofthebootoor,tightenthesparewheel
retainingnuts,andputthereplacedwheelabovethe
toolboxinthewellintheloadspaceoor(facedown).
Lowerthebootoor,andputthebootstorageboxon
thebootoor.
268