Page 8
Safety
thermoMETER CT
Protect the sensor cable against damage.
> Destruction of the sensor, failure of the measuring device
Do not kink the sensor cable and bend the sensor cable in tight radius. The minimum bending radius is
14 mm (static). A dynamic movement is not allowed.
> Damage to the sensor cable, failure of the measuring device
No solvent-based cleaning agents may have an effect on the sensor (neither for the optics nor the housing)
> Damage to or destruction of the sensor
Avoid abrupt changes of the ambient temperature.
> Inaccurate or incorrect measurements
1.3 Notes on CE Marking
The following apply to the thermoMETER CT:
- EU Directive 2014/30/EU
- EU Directive 2011/65/EU, “RoHS“ category 9
Products which carry the CE mark satisfy the requirements of the EU directives cited and the European har-
monized standards (EN) listed therein. The measuring system is designed for use in industrial environments
and meets the requirements.
The EU Declaration of Conformity is available to the responsible authorities according to EU Directive, article
10.
To Next Page
Loading...
Need help?
General
