Miditemp MP 22-W - Controlling the Active Bank in each Group; Bank Select Command before Program Change; Simultaneous Control of Several Banks

MIDITEMP MP 22-W, MP 22-CD, MP 88-W, MP 88-CD, PMM 88-E, MT 16-X
MIDITEMP MP 22-W, MP 22-CD, MP 88-W, MP 88-CD, PMM 88-E, MT 16-XMIDITEMP MP 22-W, MP 22-CD, MP 88-W, MP 88-CD, PMM 88-E, MT 16-X
MIDITEMP MP 22-W, MP 22-CD, MP 88-W, MP 88-CD, PMM 88-E, MT 16-X
103
6.10.2 Controlling the active Bank in each Group
6.10.2 Controlling the active Bank in each Group6.10.2 Controlling the active Bank in each Group
6.10.2 Controlling the active Bank in each Group
Turning
!
past the 128 Banks you will find the entries “
G=1
“ to “
G=8
“ and “
G=S
“.
➊
Set the MIDI channel on which remote control is to happen and press
.
➋
Set the Group whose active Bank is to be controlled and press
.
The Matrix Program in this Group’s active Bank can now be changed without changing the
Bank.
6.10.3 Bank Select command before Program Change
6.10.3 Bank Select command before Program Change6.10.3 Bank Select command before Program Change
6.10.3 Bank Select command before Program Change
Turning
!
further past “
G=S
“ you will find the entry “
Ctrl.0
“.
➊
Set the MIDI channel on which remote control is to happen and press
.
➋
Select “
Ctrl.0
“ and press
.
Now you can (and should) send a Bank Select command (Control 0). The Bank which is
selected and activated by this command is changed via the Program Change command which
follows it.
6.10.4 Simultaneous control of several Banks
6.10.4 Simultaneous control of several Banks6.10.4 Simultaneous control of several Banks
6.10.4 Simultaneous control of several Banks
One technique which may prove useful for you is that of allocating the same MIDI channel
to a Matrix Bank and a Song Bank. When a Program Change is received it can be used to call up a
Song and a suitable Matrix program simultaneously.
➊
Set the MIDI channel on which remote control is to happen and press
.
➋
Select a Matrix Bank (1 to 64) on which Program Changes are to have direct effect and
press
.
➌
Select a Song Bank (65 to 128) on which Program Changes are to have direct effect and
press
.
&
Use the “
Read
“ function to check that you have only programmed the switch that you
wanted – it’s all too easy to program more than one!