Miditemp MP 22-W - Starting a Job; Jumping to Specific Job Commands; Job Runtime Display; Saving and Loading a Job

MIDITEMP MP 22-W, MP 22-CD, MP 88-W, MP 88-CD, PMM 88-E, MT 16-X
MIDITEMP MP 22-W, MP 22-CD, MP 88-W, MP 88-CD, PMM 88-E, MT 16-XMIDITEMP MP 22-W, MP 22-CD, MP 88-W, MP 88-CD, PMM 88-E, MT 16-X
MIDITEMP MP 22-W, MP 22-CD, MP 88-W, MP 88-CD, PMM 88-E, MT 16-X
75
➍
Pressing
will delete the current step (shown in square brackets).
&
You can press (
HLP
) before each entry. This key displays the abbreviated names of all
the commands in the lower line.
In the upper line the full title of the current command is shown.
%
Quit this function by pressing
The Job is automatically give the name “
NO_NAME.MPJ
“. (For naming the Job use the „Save
Song“ function (see page 21) and rename as written on page 17)
5.3 Starting a Job
As for Songs, you can load a Job from the Assign file, then start it using or by MIDI
Program Change (see page 14). In normal mode an existing Job is indicated by the word “
JOB
“ in
the display. When a Job is active, the letter “
J
“ appears instead of the arrow in both lines of the
display.
While a Job is active it is impossible to call up a Matrix or Sequencer function!
While a Job is active it is impossible to call up a Matrix or Sequencer function!While a Job is active it is impossible to call up a Matrix or Sequencer function!
While a Job is active it is impossible to call up a Matrix or Sequencer function!
Only Performance mode and the MIDI eye window can be selected and operated without restriction.
5.4 Jumping to specific Job commands
Every now and then you may wish to start a Job from a step part-away through the chain
instead of from the beginning. To do this, call up the Job function, find the required starting point
with the
!
and confirm with . You will quit the Job function, and the Job will start immediately
from the chosen starting point, and you will see the “Job runtime display“.
5.5 Job runtime display
Here will be displayed which command step of the Job is currently in progress. If you press
while a Job is in progress, you can see the Job Chain just as in the passage “Edit Job“. The
only difference is that you cannot change anything by now. To the right of the display “
RUN
“ is
displayed. Press
to leave this mode.
5.6 Saving and loading a Job
Since Jobs are handled exactly like Songs, disk operations are exactly the same, too. The
Job name is saved in the Assign file along with the Song names, and the Job itself is saved to disk
like a Song.