Miditemp MP 22-W - Select a Song; Selecting a New Song Memory Place; Switching Songs Via MIDI; Select a Song Bank

MIDITEMP MP 22-W, MP 22-CD, MP 88-W, MP 88-CD, PMM 88-E, MT 16-X
MIDITEMP MP 22-W, MP 22-CD, MP 88-W, MP 88-CD, PMM 88-E, MT 16-XMIDITEMP MP 22-W, MP 22-CD, MP 88-W, MP 88-CD, PMM 88-E, MT 16-X
MIDITEMP MP 22-W, MP 22-CD, MP 88-W, MP 88-CD, PMM 88-E, MT 16-X
4
7
1.1 Select a Song
1.1.1 Selecting a new Song memory place
1.1.1 Selecting a new Song memory place1.1.1 Selecting a new Song memory place
1.1.1 Selecting a new Song memory place
➊
Press
to switch into the Sequencer mode.
➋
Choose the Song memory place into which the Midifile shall be loaded. Use
!
, or the
numeric keys
to , and press . The arrow in front of the “S“ turns to black.
&
If there is no song on that memory place you will find a blank line.
If there is already one stored on this Song memory place the depending Song will
immediately be loaded and be ready for playback (indicated with the bar counter, too).
If there is one Song stored on this place, but the medium on which that file should stay is
not ready, you get an error message.
1.1.2 Switching Songs via MIDI
1.1.2 Switching Songs via MIDI1.1.2 Switching Songs via MIDI
1.1.2 Switching Songs via MIDI
All the 128 Song memory places in a Song Bank (this works, of course, even if you have
changed the Song numbering mode! see page 39) can be called up using the “program change“
message via any MIDI input, as well as from each MIDI channel. The different Song banks can be
switched via different MIDI channels, or via the „bank select“ message (controller no. 0). (RMT, see
page 102). The remote settings have to be activated in the Matrix mode.
1.2 Select a Song Bank
The numbering of Song banks is similar to that of Matrix banks, but their organisation is
quite different. The basic concept is: only one song may run at once! For this reason there is only
one Song group (Remember: only one Bank can be active per Group). However, to keep the Song
performance as flexible as possible, instead of eight Banks, the Song Group has 56, each with 128
Program memories. This gives a total of 7.168 Songs, which should be enough for every
conceivable application. If not you just open a second ASSIGN, in which you have the next possible
7.168 entries ....
$
Press
to switch into the Sequencer mode.
$
Press
.
The Bank select menu appears; the LED for the active Bank lights up. Banks 65 to 72 are
assigned to the number keys (
to ). In the top right the display shows that the Song Group
is being selected (G=S). Using
!
the next Banks are displayed.
No.: 65 66 67 68 69 70 71 72 G=S
Name:S1A