MIDITEMP MP 22-W, MP 22-CD, MP 88-W, MP 88-CD, PMM 88-E, MT 16-X
MIDITEMP MP 22-W, MP 22-CD, MP 88-W, MP 88-CD, PMM 88-E, MT 16-XMIDITEMP MP 22-W, MP 22-CD, MP 88-W, MP 88-CD, PMM 88-E, MT 16-X
MIDITEMP MP 22-W, MP 22-CD, MP 88-W, MP 88-CD, PMM 88-E, MT 16-X
119
F Error Messages
Error message
Error messageError message
Error message
CRC error
CRC errorCRC error
CRC error
The data on the inserted floppy disk is corrupted..
directory exceeds
directory exceedsdirectory exceeds
directory exceeds
A directory or folder contains more than 1000 files.
disk full
disk fulldisk full
disk full
There is not enough space on the medium to save the file.
disk structure bad
disk structure baddisk structure bad
disk structure bad
None of the above faults were found, yet the disk cannot be read.
file not found
file not foundfile not found
file not found
The file which is to be loaded does not reside on the selected drive.
MIDI buffer full #
MIDI buffer full #MIDI buffer full #
MIDI buffer full #
A MIDI bottleneck at one of the MIDI ports has caused the MIDI buffer memory to
overflow. The number and name of the afflicted port is displayed along with this
message. An output can only overflow when too much data arrives at it, during Send
Data or SysEx transmissions.
MIDI data error #
MIDI data error #MIDI data error #
MIDI data error #
This message warns of incomplete MIDI data at one of the inputs, i.e. the bit count of an
individual MIDI byte (start bit, bit data, stop bit) was wrong. Possible causes are: poor
cables, too many thru-in connections before the data reaches the MULTIPLAYER, or a
synthesizer has emitted a burst of random “garbage“ as it was switched on.
no data
no datano data
no data
The medium is unformatted, or of the wrong format.
no directory space
no directory spaceno directory space
no directory space
There are too many files in the root directory or folder.
no disk
no diskno disk
no disk
There’s no floppy disk in the drive.
No memory reserved for
No memory reserved forNo memory reserved for
No memory reserved for
waveplayer!
waveplayer!waveplayer!
waveplayer!
You attempted to switch into Wave mode although there was no memory reseved for the
Wave Player.
no response
no responseno response
no response
The selected SCSI device is not responding.
out of memory
out of memoryout of memory
out of memory
The MULTIPLAYER’s Song memory is full. Either there is not enough room to load a Song
from disk, or, when recording, there is no room for incoming data. In this case recording
will stop on the track which experienced the problem, and any data already recorded on
that track will be deleted. However, recording will continue on any other tracks.
Processing-Resources
Processing-ResourcesProcessing-Resources
Processing-Resources
exceeded!
exceeded!exceeded!
exceeded!
Too many data processors (Filter, Split, Transpose etc.) have been used.
reservation conflict
reservation conflictreservation conflict
reservation conflict
Two SCSI devices have the same SCSI ID.
Routing-Resources
Routing-ResourcesRouting-Resources
Routing-Resources
exceeded!
exceeded!exceeded!
exceeded!
Too many or too complex routings have been programmed. This and the previous
message only occur when a single device is being overstretched within a FORNET setup.
SCSI error #
SCSI error #SCSI error #
SCSI error #
An error has occured in one of the SCSI devices (the error number is sent by the relevant
device, an error list you may find on www.miditemp.com)
sector not found
sector not foundsector not found
sector not found
A sector on the disk could not be found, or is corrupted.
Sequencer program must
Sequencer program mustSequencer program must
Sequencer program must
be a JOB!
be a JOB!be a JOB!
be a JOB!
The »job« function has been called up but the program is a
Standard MIDI File
. Select
an already existing JOB or a free Song memory place.
System buffer full
System buffer fullSystem buffer full
System buffer full
During a transmission of SysEx data, especially Matrix Banks; the programs of the
receiver should be cleared up first, then repeat the transmission.
unsupported format
unsupported formatunsupported format
unsupported format
The format of the disk has been recognized as incorrect.
Wave memory full!
Wave memory full!Wave memory full!
Wave memory full!
There is no memory space available for additional waves.
write protected
write protectedwrite protected
write protected
The disk is write-protected. Double-check you really want to add something to this disk. If
so, close the small plastic protect tab of the disk, replace it in the drive, press
.
To Next Page
Loading...