EasyManua.ls Logo

Miditemp MP 22-W - Songspecific Assign of Wave Files

Default Icon
131 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MIDITEMP MP 22-W, MP 22-CD, MP 88-W, MP 88-CD, PMM 88-E, MT 16-X
MIDITEMP MP 22-W, MP 22-CD, MP 88-W, MP 88-CD, PMM 88-E, MT 16-XMIDITEMP MP 22-W, MP 22-CD, MP 88-W, MP 88-CD, PMM 88-E, MT 16-X
MIDITEMP MP 22-W, MP 22-CD, MP 88-W, MP 88-CD, PMM 88-E, MT 16-X
109
Press
.
The LED of the number key right below number 0 lights up. Depending on if you have a
device with or without hard disk, either the entire Wave has been loaded from the inserted floppy
disk, or, the first data blocks of the Wave have been loaded from hard disk. If you press this key
shortly the Wave will be played in fully length. If you hold the key, the Wave will only be played, until
you release the key. On one Bank you can assign as many Waves as there are MIDI note numbers.
Repeating these steps, you can now assign different Waves to other note numbers.
%
Quit this function by pressing
.
&
If you started a Wave by shortly pressing a depending number key you can stop the
playback by pressing another number key. If there is another Wave assigned to that key the
next Wave will start to playback, if there is none assigned to the key the Wave Player is
stopped.
5.4 Songspecific Assign of Wave files
With the songspecific assign of Waves you get the possibility just by selecting a Song to load
all depending Audio files to this Song into the memory with one function. Working like this you don’t
need to hold all Waves in the memory at once. On the other side you can use the same MIDI
channel, key range and note-assignment for each Song (but with different Waves, of course). The
assignment of the Waves to Songs has to be done via the “
WVH
“-Bank, which is especially reserved
for this purpose.
PROCEDURE
PROCEDUREPROCEDURE
PROCEDURE
Select the Song memory playce with the MIDI File Waves shall be assigned to.
$
Press
and select with the “WVH“ Bank.
Assign the needed Waves to the different notes (as written in 5.3, page 108). Every setting
will automatically registered by the MULTIPLAYER.
Don’t forget to save your Assign file to store the new settings!
ave: WVA C-2 WAVEDEMO.WAV
!
!!
!
( 0) 1 2 3 4 5 6 7
#
##
#

Table of Contents