Cleaning agent and rinsing agent
33
Replacing the canister
Place the liquid cleaning agent container
(note the colour marking) on the open
wash cabinet door or on a surface which
is robust and easy to clean.
Take the lid off the canister and remove
the suction lance. Place the suction lance
on the open wash cabinet door.
Replace the empty container with a full
one.
Push the suction lance into the opening of
the container and secure the lid. Observe
the colour coding.
Feed the suction lance into the container
until it reaches the bottom.
Wipe up any spilled process chemical
thoroughly.
Checking consumption
Check consumption regularly by checking
the fill levels in the supply containers and
replace containers in good time to avoid the
dispensing system being sucked completely
dry.
Dispensing liquid cleaning agent
The dispensing concentration is set by the
Miele Customer Service Department.
Rinsing agent
Rinsing agent is necessary to ensure water
does not cling and leave marks on load
items, and to help load items dry faster after
the final rinse.
The rinsing agent concentration must be ad-
justed in the following circumstances:
- If there are spots of water left on load
items after reprocessing, then the dis-
pensing concentration is set too low.
- If clouding or smearing appears on load
items, the dispensing concentration is set
too high.
The rinsing agent is dispensed in the Final
rinse programme stage. The container
needs to be filled for this purpose.
In the Beer glasses programme (depending
on the model), the final rinse is carried out
with cold water and without rinsing agent.
Refill indicator
When the fill level in the rinsing agent con-
tainer is low, you are reminded to refill the
dispenser container, e.g.:
Information
Fill rinse aid into
door dispenser.
OK
Confirm the prompt with OK and top up
the rinsing agent as described.
Fill the dispensing path (see “Machine
functions”)
To Next Page
Loading...
