Miele PFD 400 - Adjustable Plinth Panel (Depending on the Model)

Installation
*INSTALLATION*
93
Adjustable plinth panel
(depending on the model)
Dishwashers with internal dispensing or act-
ive drying have an adjustable plinth panel.
 Level the dishwasher.
 Open the dishwasher door halfway and
loosen the two screws now visible at the
top of the plinth panel.
 Pull the plinth panel upwards first and
then forwards.
 Loosen the two screws on the right and
left of the plinth behind the panel.
 Pull the inside of the plinth down to the
floor.
 Tighten the two screws again.
 Reassemble the plinth panel by following
the instructions above, but in reverse or-
der.
Removing the machine lid
If the dishwasher is fitted with a lid, it can be
removed as follows:
 Remove both securing screws on the
back of the dishwasher with a screwdriver.
 Open the door.
 Unscrew the left and right fastening
screws with a screwdriver.
 Lift the machine lid upwards to remove.