Maintenance
87
Cleaning the water inlet filter
A filter is incorporated in the screw thread to
protect the water intake valve. If the filter is
soiled, insufficient water flows into the wash
cabinet.
Risk of electric shock from mains
voltage.
The plastic housing of the water connec-
tion contains an electrical valve.
The housing must not be dipped in water.
Disconnect the dishwasher from the
mains.
To do this, turn off the dishwasher, switch
off at the socket and unplug it.
Close the stopcock.
Unscrew the water intake valve.
Remove the seal from the screw thread.
Using combination or pointed pliers, take
hold of the plastic filter bar and remove
the filter.
Rinse the filter under running water.
Reassemble in reverse order.
Screw the screw thread securely back
onto the stopcock. Slowly turn on the
stopcock. If water drips out, tighten the
connection.
Never forget to put the filter back in place
after cleaning.
To Next Page
Loading...
