Miele PFD 400 - Water Inlet and Drainage Faults

Problem solving guide
79
Faults with water inlet or drainage
Problem Cause and remedy
One of the following fault
messages or notifications
appears on the display:
Before rectifying the problem:
 Switch the dishwasher off with the button.
F404 Water inlet, cold too
low: check water inlet. Open
stopcock fully. Turn appliance
off and on. Restart pro-
gramme. If fault persists, con-
tact customer service. Ser-
vice phone: Serial number:
Water inlet fault.
 Open the stopcock fully.
 Clean the water inlet filter (see “Cleaning and Care”).
F541 Water drainage: Turn
appliance off and on. Start
“Drain” programme. Clean fil-
ter combination and non-re-
turn valve. If fault persists,
contact customer service.
Service phone: Serial number:
Water drainage fault. There might be water in the wash
cabinet.
 Clean the filter combination (see “Cleaning and care”).
 Clean the drain pump, see “Problem solving guide”.
 Clean the non-return valve (see “Problem solving guide”).
 Remove any kinks or loops in the drain hose.