Miele PFD 400 - Cancelling Programmes with Fault Numbers

Problem solving guide
80
Cancel with fault number
If a programme is cancelled and a fault number appears, e.g. Fault F XXX (where XXX rep-
resents a number), there could be a serious technical fault.
In the event of a programme being cancelled and a fault number being shown:
 Switch the dishwasher off with the button.
 Wait approximately 10seconds before switching the dishwasher on again with the
button.
 Start the previously selected programme again.
If the same fault message appears again:
 Make a note of the fault message.
 Switch the dishwasher off with the button.
 Contact the Miele Customer Service Department.
Please also read the notes regarding the following fault numbers.
Problem Cause and remedy
Fault F 404–405 If Check water inlet appears on the display, the control sys-
tem is checking the water intake approx. every
30seconds. If, after three attempts, water is not getting
into the dishwasher, one of these fault numbers will appear
on the display and the programme will be cancelled.
 Open the stopcock fully.
 Switch the dishwasher off and back on again.
 Select the programme you want to use.
 Press the Start/Stopbutton.
Fault F 407–408 Water inlet fault.
If the flow pressure is too low, one of these fault numbers
will appear on the display and the programme will be can-
celled.
 The flow pressure at the water connection is too low (see
“Technical data”). Contact the Miele Customer Service
Department for advice.
Fault F 413–414 Water inlet fault.
If the flow pressure is too high, one of these fault numbers
will appear on the display and the programme will be can-
celled.
 The flow pressure at the water connection is too high
(see “Technical data”). Contact the Miele Customer Ser-
vice Department for advice.
Fault F 492, 541 The programme has not started properly. There might be
water in the wash cabinet.
 Clean the filter combination (see “Cleaning and care”).
 Clean the non-return valve (see “Problem solving guide”).