Miele PFD 400 - Increased Water Level; Interim Rinse; Resetting Parameters

Further settings
63
Increased water level
It is then advisable to increase the water
level when a lot of water is absorbed due to
the structure of the load items or when the
type of soiling and the process chemicals
used lead to excess foam development. The
additional volume of water depends on the
type of basket or mobile unit used, the type
of soiling and the load items.
If slightly soiled load items which absorb a
little water are being reprocessed, the water
level can be reset to the factory default set-
ting to save water and energy.

Increas. water
quan.
0,5
- + OK
l
 Set the additional volume of water by tap-
ping the -symbol (lower) and +symbol
(higher). In the lowest setting, the volume
of water corresponds to the factory de-
fault setting.
 Press OK to save the setting
Interim rinse
If required, an additional intermediate wash
block can be activated for selected pro-
grammes.
You can find out which programmes support
this function in the “Programme chart”.

Interim rinse
On
Off
- On
Activates the additional intermediate wash
block for the selected programme.
- Off
Deactivates the additional intermediate
wash block.
 Tap to select an option.
Resetting parameters
You can reset individual programmes to the
factory default settings. The programme
parameters and changed programme
names are reset.
Reset programme parameters?
Yes No
 Select Yes to reset the parameters and
programme names to the factory default
settings.
 Select No to cancel the process.