Miele PFD 400 - Rinsing Dispensing Paths

Machine functions
48

Fill disp. paths
Cleaning ag.
canister
Rinse aid
canister
- Clean. agent canister
Fill the cleaning agent dispensing system.
- Rinse aid canister
Fill the rinsing agent dispensing system.
 Select the dispensing system that you
want to fill.
You will then be asked if you want to start
the filling process, e.g.:
Start filling dispensing paths?
No Yes
 Select Yes to start the process.
The dispensing system is filled automatic-
ally. The message Fill dispensing paths
completed is displayed following success-
ful completion. If filling is interrupted pre-
maturely, the process must be repeated.
 Cancel the process at this point by select-
ing No.
Rinsing dispensing paths
A dispensing system must be rinsed in the
following situations:
- If a dispensing system was accidentally
filled with the wrong medium.
- If deposits have formed in the dispensing
paths or in the containers, which could
completely or partially clog the systems.
Deposits can form, for example, after long
periods of downtime or when the contain-
ers are refilled instead of being replaced.
 Fill a clean container, e.g. a bucket, with
clear, clean water.
 Damage to the dispensing system.
Small foreign objects in the water, such
as sand, fluff or similar, can be sucked in
by the dispensing system and may clog
or damage it.
Make sure that there are no foreign ob-
jects in the water.
 Place the suction lance in the container
with the water. The lower end of the suc-
tion lance with the suction opening must
be thoroughly rinsed.
 Secure the suction lance so that it cannot
tip over or fall out of the container.