Miele PFD 400 - Programme Sequence Details

Programme chart
91
Programme sequence
1.
Pre-wash
2.
Pre-wash
3.
Main wash
(1)/(2)
4.
Interim
rinse
5.
Interim
rinse
6.
Final rinse
(1)/(2)
X X
55°C
1min
(X) X
60°C
1min
X X
55°C
2min
X (X) X
60°C
1min
X X X
65°C
3min
X (X) X
60°C
1min
X X
60°C
2min
X (X) X
55°C
1min
X
55°C
30s
(X) X *)
55°C
30s
X
50°C
1min
X (X) X
– (3)
1min
X X
70°C
10min
X (X) X
60°C
1min
X
50°C
1min
X (X) X
50°C
1min
X X
50°C
5min
X (X) X
60°C
1min
X
46°C
15min
X (X) X
50°C
2min
Reactivation sequence
X
X
*) Important note for the Super short programme
With the Super short programme, water from the final rinse is not pumped away at the end of the programme. It will be used as the
cleaning water in the next Super short programme.
If the water temperature drops below 40°C or if another programme is started, this water will be automatically pumped away when the
programme starts.
X= stages included in a programme
(X)= optional stages which can be selected (set by the Miele Customer Service Department)
(1)Temperature ranges from 30–70°C (set by the Miele Customer Service Department)
In the Super short programme, the temperature can only be increased to a maximum of 70°C
(2)Holding time ranges from 0–10minutes (set by the Miele Customer Service Department)
In the Super short programme, the holding time can only be from 0–255seconds
(3)Runs with cold water and without surfactant