Miller PipeWorx 400 - Changing Wire Feed Speed from Inches Per Minute (IPM) to; Meters Per Minute (MPM)

OM-253 906 Page 21
5-5. Changing Wire Feed Speed From Inches Per Minute (IPM) To
Meters Per Minute (MPM)
805 298-A / 805 429-A
! Turn Off welding power
source, disconnect input
power, and check voltage
on input capacitors
according to Section 7-6
before proceeding.
1 PipeWorx Feeder
2 Operator Interface Board
3 Dip Switch
Remove feeder wrapper.
Move number 1 switch (top switch)
to the ON position. Use a small
screwdriver to move switch, if
necessary.
Reinstall wrapper.
Tools Needed:
5/16 in.
1
2
3
Rear View Of
Wire Feeder
Front Panel