EasyManuals Logo

Miller PipeWorx 400 User Manual

Miller PipeWorx 400
116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
OM-253 906 Page 31
5-13. Assembling And Installing Cable Hanger
805 148-B / 805 141-A
1 Bracket
2 Tube Cap (4)
3 Cable Holder Tube (2)
Install caps in tubes.
Assemble cable holder tubes to
bracket using supplied hardware.
Place cable holder assembly on top
of power source or cart and set wire
feeder on cable hanger.
Tools Needed:
7/16 in.
3/8 in.
1
2
3

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Miller PipeWorx 400 and is the answer not in the manual?

Miller PipeWorx 400 Specifications

General IconGeneral
Amperage Range5 - 400 A
Duty Cycle60% at 400 A
ProcessesMIG, Flux-Cored, Stick, DC TIG, Pulsed MIG
Output Voltage Range10 - 44 V
Wire Feed Speed50 - 780 IPM

Related product manuals