Milnor E-P Express Reference Manual

Pellerin Milnor Corporation 17
menus. The Terminate button has no effect after the Configure menu has been accessed, or
after any parameter of any formula has been accessed in the Add/Change Formula menu.
3. The Manual button is not used in the programming mode.
4. The Operator Signal light is not used in the programming mode.
5. The Signal Cancel button is not used in programming.
6. Use the Next button (
) to confirm any choice and move to the next decision in the
sequence.
7. The display presents the programming menus and choices within those menus, including all
configuration and formula parameters.
8. The Scroll Up button (
) scrolls the available choices upward from the lowest available
number.
9. Use the Scroll Down button (
) to change the selected programming parameter to the next
lower-numbered choice.
10. The Door unlock button (
) has no function in programming mode.
11. The Run/Program keyswitch allows programming when set to
. The Program menu in-
cludes selections for adding and changing wash formulas, configuring the controller, and re-
storing the standard formulas provided with the machine. The keyswitch must be set to the
Run position (
) for normal machine operation, as described in Section 2.1.1 : Control
Functions During Normal Operation, page 14 .
12. The Run Indicator light is not actuated during programming.
BNCJVC01 / 2018382
BNCJVC01 0000181472 C.3 1/2/20 1:16 PM Released
2.2 Selecting an Industry Formula Set
BNCJVC01.C01 0000181471 A.4 C.3 1/2/20 1:16 PM Released
This document gives data about all current Milnor
®
E-P Express
®
controlled washer-extractors
and Milnor
®
E-P Plus
®
controlled washer-extractors with one type of processor board. You can
identify this board by “P/N 08BH18EP_ ” near the Milnor
®
symbol on the processor board.
The Milnor
®
factory sets each washer-extractor controller for the specified operation. You can
change the DIP switches on the processor board to change the machine configuration for a differ-
ent operation. This document describes how to set the DIP switches. A different operation name-
plate is necessary on some models. Get operation nameplates from your dealer or the Milnor
®
parts department.
To change industry configuration, turn the machine off. Then lock off and tag out power to the
machine at the wall disconnect before accessing the processor board.
Programming

Milnor E-P Express Specifications

General

Brand	Milnor
Model	E-P Express
Category	Control Unit
Language	English