34
Pellerin Milnor Corporation
CAUTION:
Avoid Data Loss — Other than the two methods described above, it is not
possible to selectively delete field-modified or field-programmed formulas
with this programming mode. This mode erases all field-programmed for-
mulas 1 through 10 or 1 through 30 as specified. For selective deletions
and modifications, use Program mode 1 (Add/Change Formula).
CAUTION: Avoid Chemical Damanage to Goods — The injection time for Chemical
1 is 30 seconds for all default formulas. This may prevent certain supply
systems from properly detecting which formula is running, or cause the in-
jection time for chemical 1 to be longer than intended.
� Always verify the Chemical 1 injection time for each formula after re-
storing the standard formulas
2.3.5.1 Chart 1: Restore Standard Formulas (Part A)
BNCJUP02.T01 0000191350 A.4 A.8 A.6 1/2/20 1:16 PM Released
1. Start
2. Restore standard formulas?
This procedure replaces field-modified wash formulas with the standard formulas provided
by Milnor
®
.
• YES: Continue to step 3
• NO: Skip to 1.: step 1, Part C, page 35
3. Enable Program menu
Turn the Run/Program keyswitch to set the controller to the Program mode.
4. Select and Enable Standard Formulas
Scroll to Standard Formulas (item 3 of the Program Menu), then confirm the selection.
5. Clear formulas 11 - 30?
Do you want to keep or clear formulas 11 through 30?
• YES: Continue to step 6
• NO: Skip to 1.: step 1, Part B, page 35
6. Select and Confirm Default 30 Formulas
Continue with this procedure to replace formulas 1 through 10 with the standard formulas and
erase formulas 11 through 30.
7. Standard formulas written to memory
The controller will pause for a few seconds while the standard formulas are written to the con-
troller memory.
8. Return to Run mode
When the display becomes active again, turn the Run/Program keyswitch to the Run
position.
Programming
To Next Page
Loading...
