52
Pellerin Milnor Corporation
3 Operating
BNCJHO03 / 2018432
BNCJHO03 0000208872 1/2/20 1:16 PM Released
3.1 Running a Formula
BNCJHO03.C01 0000208871 A.4 A.3 1/2/20 1:16 PM Released
3.1.1 Applying Power
BNCJHO03.C02 0000208870 A.4 A.3 1/2/20 1:16 PM Released
Display or Action Explanation
The Run/Program keyswitch must be set to the Run position be-
fore the main wall disconnect (fuse or circuit breaker) is closed to
provide power to the machine.
When power is first applied to the machine, the display shows the software copyright informa-
tion, machine name, and the checksum number. The checksum number changes with any pro-
gramming change. To detect unauthorized programming, record the checksum at the end of each
authorized programming session and compare it to the checksum displayed at each power up.
Milnor
®
washer extractors with E-P Express
®
controls do not use a speed sensing device to verify
that the basket has stopped rotating. Therefore, when power is first applied to the machine, at
least 80 seconds must elapse before any further operations can be attempted. This provides suffi-
cient time for the basket to coast to a complete stop if power was lost while the machine was in
high speed extract and restored before the basket stopped.
DANGER: Entanglement Hazard — The linen inside or hanging partially outside a
turning cylinder can suddenly wrap around your hand, arm, or body. The
inertia of the spinning cylinder can cause the entangled linen to twist off or
sever body parts. You can be killed or seriously injured.
� Never put any part of your body inside this machine or touch the linen
while the machine is turning.
3.1.2 Selecting and Starting the Formula
BNCJHO03.C03 0000208869 A.4 A.3 1/2/20 1:16 PM Released
3.1.2.1 Load Machine and Close Door
BNCJHO03.C04 0000208868 A.4 A.3 1/2/20 1:16 PM Released
Load the machine to the rated capacity and securely close the loading door. Review Section 1.2 :
Determining Load Size, page 4 for guidelines on loading machines.
To Next Page
Loading...
Need help?
General
