Chapter 5 Using the XY Slitter
126
21
Turn the take-up unit switch to OFF.
• "Take-up unit"(P. 58)
• The torque limiter should ideally be set to "Mid". "Adjusting the Torque Limiter"(P. 58)
22
Press to feed the media.
• Decrease the media tension slightly.
23
Turn the take-up unit switch to ON.
• "Take-up unit"(P. 58)
24
Unlock the tension bar of the XY slitter.
• Tension is applied to the media.
25
Secure the media in the media holder.
• Do not use the media holder when printing on thicker media.
To Next Page
Loading...
