MIMAKI CJV330-160 - Chapter 6 Settings; Media Setting Menu

Chapter 6 Settings
140
6.1 Media Setting Menu
When you use the machine for the first time, the Select Use Media screen is displayed. "Registering the
Media"(P. 72) The media Information and correction value can be saved in advance for specific media.
l
Menu List
The user can select to prioritize the settings on the machine or the settings on the PC. Setting individual
menus to "Host" prioritizes PC settings. To prioritize settings for this machine, select a setting other than
"Host".
• For more information on how to specify RIP software, refer to the RIP software operating
manual.
Item Setting Details
*1 *2
Feed Comp. -9999 to 0 to
9999
- Corrects the media feed amount.
• Print a pattern and enter the correction amount. "Feed
Correction"(P. 79)
Drop.PosCorrect - - Corrects the drop position for bi-directional printing.
(Resolution) All/300std/600
std/600hi/800
std/800hi
- Select the resolution to be corrected. When "All" is selected,
correction patterns for all resolutions will be printed.
(Correction
Value)
-40.0 to 0 to
40.0
- Check the pattern and enter correction values.
Auto-correction - - Detects a correction pattern with the sensor and automatically
corrects the drop position (automatic correction function:
DAS). When "All" is selected, [Feed Comp.] and
[Drop.PosCorrect] are corrected.
• Check to confirm that the media does not lift up.
• Load white and clean media.
• Synthetic paper or cloth media may not be detected.
• Do not send the RIP data from the PC during pattern
printing.
• If automatic correction is unsuccessful, correct the position
manually. [MENU] > [Media Setting] > [Feed Comp.] or
[Drop.PosCorrect]
All -
Feed Comp. - -
Drop.PosCorrect - -
(Resolution) All/300std/600
std/600hi/800
std/800hi
- Select the resolution to be corrected. When "All" is selected,
correction patterns for all resolutions will be printed.
(Correction
Value)
-40.0 to 0 to
40.0
- Check the pattern and enter correction values.
MAPS4 - - MAPS: Mimaki Advanced Pass System
• This function disperses the boundaries between passes to
make feed streaks between passes less visible.
• Altering MAPS may alter the color. This function may be
less effective with certain types of images.
MAPS4 AUTO/
MANUAL
- This should normally be set to "AUTO". When set to
"MANUAL", the following items are displayed:
Speed 50 to 100 % - Reducing speed will make streaks less visible. However,
printing will be slower.