MIMAKI CJV330-160 - Environment Setting Menu

Chapter 6 Settings
149
6.4 Environment Setting Menu
This is used to set various operations to ensure optimal machine performance.
l
Menu List
Item
Setting
*1
Details
LANGUAGE English / 日本
語 / Deutsch /
Português /
Español/
Italiano /
Korean
Sets the display language.
Time Set -20 to 0 to +4
h
Sets the current time and date. (With respect to JST)
• This can be set within the range of -20 to +4 hours.
Key Buzzer ON/OFF Sets an audible tone when keys are pressed.
• Audible signals indicating errors, warnings, and operation end
cannot be muted, even if "OFF" is selected for this setting.
Unit Setting - Set the display units.
Temp. °C/°F Sets the display unit for temperature (Celsius/Fahrenheit).
Length mm/inch Sets the display units for length and area.
• Some items are displayed in "mm" even if "inch" is selected.
Network - Sets the network address. The machine must be restarted to enable
this setting.
Check Ip
Address
- Displays the machine's current IP address.
• It may take some time to determine the IP address. If the IP
address cannot be determined, the display will indicate "0.0.0.0".
Check MAC
Address
- Displays the machine's current MAC address.
DHCP ON/OFF Select "ON" to use the IP address assigned by the DHCP server.
AutoIP ON/OFF Select "ON" to use the IP address set by the AutoIP protocol. Note
that DHCP takes priority if DHCP is set to "ON".
Remote Control - Mimaki Remote Access (MRA) is required to use the remote control
function. MRA is a remote access tool installed on a computer or
smartphone that allows viewing of product information and panel
operation from a remote location away from the 330 series (within
the same network segment).
Specify the following settings to use this.
Setup Enable/
Disable
Enable/disable remote control.
PIN code 0000 to 9999 Enter the same PIN code as MRA. The PIN code is used for
authentication between the machine and MRA.
• When the machine is set to "0000", MRA can access the
machine with any PIN code.
KeyLife 5 to 30 to 120
min
The key life time is the time until the machine and MRA are
disconnected when there is no activity on the MRA.
Machine Reset - Initializes the details set.
*1. The default settings are shown underlined.
6