Chapter 5 Using the XY Slitter
122
5.2 Loading the Media
• Adjust the head height before loading media. Moving the carriage after the media has been
loaded may result in the print head coming into contact with the media and being damaged.
• For instructions on how to load media, refer to "Loading the Roll Media"(P. 62) (Steps 1 to
12).
1
Load an empty core on the take-up unit.
2
Move the X cutter to the side and raise the lever to secure it.
• Avoid touching the cutter blade. Failure to do so may result in injury.
3
Detach the stopper and move the tension bar to the rear.
4
Gently pull out the media and stop at the XY slitter.
• Pull out the media until it comes 50 to 60 mm away from the underside of the XY slitter front cover.
To Next Page
Loading...
