MIMAKI CJV330-160 - Page 123

Chapter 5 Using the XY Slitter
123
5
Check how far the media was pulled out.
• Pull the front edge of the media gently at several points to confirm that the media was pulled out
by the same amount.
6
Lower the clamp lever.
• Hold the media with the pinch roller and grit roller.
7
Select the media to be used.
Media selection
● PVC
○ Tarpaulin
○ Unregistered
○ Unregistered
1/2
1300 mm
1600 mm
○ Unregistered
• To use unregistered media, select [Unregistered] to register the media. "Registering
the Media"(P. 72)
8
Detect the media width.
• No change: Only the right side of the media is detected.
• Media width re-detection: The media width is detected.
PVC
Media Width 1300 mm
No change
Media width
re-detection
• If the setting for [Media Setting] > [Media Information] > [Media Width] is "MANUAL", set
the media width manually.
• If the setting for [Media Setting] > [Media Information] > [Media Remain Manage] is "ON",
the Input Media Length screen will be displayed.
• A notification reading "Media Set Position R" will appear after media width detection if the
media is too far to the right of the specified position. Reload media in the specified
position.
9
(CJV only) Enter the number of pinch rollers being used.
• If the setting for [Function Setting] > [Use PR Number Query] is "OFF", the screen for entering the
number of pinch rollers will not be displayed.
10
On the LOCAL mode screen, select [MENU] > [Function Setting] > [Finisher] > [XY Slitter].
Post-processing selection
● XY slitter
○ Not used
5